Resetter Canon PIXMA MP280 Error Code
Resetter Canon PIXMA MP280 Error Code -Canon
Mp280 is a photo inkjet printer All in one. When the printer is turned on, the
printer looks normal. But after ordered to print, it will appear error E08 or
E13.
Then here's how to reset your printer.A. RESET PRINTER
- Turn off Canon MP287 error E08 by pressing POWER button. Do not unplug the power cord.
- Press and Hold down the STOP / RESET button followed by pressing POWER Button. So both buttons position depressed.
- Release the STOP / RESET button but do not release the POWER button.
- In the POWER button still depressed, press the STOP / RESET button 6 times.
- Then release both buttons simultaneously.
- An error printer will initialize for a few moments such as when the printer was first attempted at the time of purchase. Wait until the LCD panel on the error printer shows Black (blank).
- The MP258 printer will be detected as a new device on your computer, even though the printer driver has been installed. Just ignore this condition.
- The blank printer condition on the LCD indicates that the printer is in Service Mode and is ready to be reset using the software.
If the
power cord is unplugged, then the above step should be repeated again.
After
doing the above step, then we reset using Tool (Software)
B.
RESET SOFTWARE
- Download the MP287 resetter program on the link below this post.
- Prepare 4 - 5 papers on the Printer, because later will be used to process the reset.
- Open the MP280 series resetter program.
- see the Clear Ink counter absorber menu then select and click Main and then click SET located on the right.In the counter absorber menu counter select Main and then click SET on the right.
- Then click EEOPROM. then the printer will print 1 page.
- Canon MP287 printer that error E08 will be normal again.
- Then power off MP258 / MP250 by pressing Power button.
- Done.
To
overcome the Full Absorber Ink on MP280 canon, which is marked with the appearance
of 5B00 error code and error P07 on the printer screen, then the printer must
first we change into safe mode position, here are the steps to resetter MP280.
- The printer is off, press and hold the Resume button followed by pressing and holding the Power button. The power button is still pressed, release the Resume button and then press it again 6 times and release the Power and Resume button simultaneously.
- The computer system will detect the new driver device, ignore it.
- Now the printer is in service mode and ready to reset.
- The next step of the reset stage on your printer, prepare multiple sheets of paper because the printer will perform the process of printing documents when reset.
- on your Clear Ink Counter click Set, wait until the printer prints the document.
- The next step you click Set on Ink Absorber Counter followed by click EEPROM.
- Wait for the printer to print.
- Turn off the printer by pressing the power button and turn it back on.
- Done, now the printer has been able to be reused as usual.
That's the discussion of Jangsigma on this occasion, about how to resetter Canon MP287 error code 5B00 or P07.
may be useful.